Volume 4  Number 6 Spl., (2014)

CONTENTS

Recent Methods for Optimization of Plastic Extrusion Process: A Literature Review
pp. 583-588
Authors: Geo Raju, Mohan Lal Sharma and Makkhan Lal Meena

Experimental and Numerical Investigation of Tailor Welded Blanks [TWBs]
pp. 589-599
Authors: Hareshkumar O. Dabhi , Shashank J. Thanki and Vimal K. Patel

Establishing Relationship between ASAW Parameters and Welding Voltage during Surfacing
pp. 601-609
Authors: Hari Om and Sunil Pandey

Development of Magnetorheological Finishing (MRF)Process for Freeform Surfaces
pp. 611-618
Authors: Laxmi N. Pattanaik and Himanshu Agarwal

Sealing Valve Bell Less Top Blast Furnace Increasing Productivity
pp. 619-628
Authors: Meenu Sahu and Shiena Shekhar

Effect of Corrosion on Heat Transfer through Boiler Tube and Estimating Overheating
pp. 629-638
Author: Mohammed Imran

Modification of Al-11.1Si Alloy with Antimony through Casting Route
pp. 639-646
Authors: Mohd. Suhail Ansari, Deepak Sharma, Vikram Tomar and Vikram Jaglan

Analysis and Optimization of Parameters Affecting Surface Roughness in Boring Process
pp. 647-655
Authors: Pardeep Kumar, J. S. Oberoi, Charnjeet Singh and Hitesh Dhiman

Modeling and investigating for Cutting Speed and Dimensional Deviation in WEDM of WC-24% Co Composite using Response Surface Methodology and Desirability Function
pp. 657-666
Authors: Pardeep Kumar and Jatinder Kumar

Prediction of Surface Roughness in WEDM Process Using Feed Forward Back Propagation Neural Network
pp. 667-674
Authors: Piyush Pant, Navneet k Pandey, S.Rajesha and Gaurav Jain

Study of Vibration Analysis of Laminated Composite Plates Using FEM
pp. 675-680
Authors: Pushpendra k. kushwaha and jyoti vimal

An Investigation of Abrasive Wear in Rubber Material
pp. 681-686
Authors: Ravindra Verma, Sudhir Tiwari and Vishal Gehlot

Numerical Simulation of Heat Transfer Enhancement due to a Gap in an Inclined Continuous Rib Arrangement in a Solar Air Heater Duct
pp. 687-693
Authors: Rohit Kumar Sahu and Bhupendra. K. Gandhi

Weldability Issue of AISI 202 SS (Stainless Steel) Grade with GTAW Process Compared to AISI 304 SS Grade
pp. 695-700
Authors: Sahil Bharwal and Charit Vyas

Effect of Alloying Content on Surface Roughness of Die Materials at Optimal Parametric Condition using WEDM
pp. 701-712
Authors: U. K. Vates, N. K. Singh and R. V. Singh